Good Make in Gem Stones

Having now had a glimpse of the methods of the lapidaries, let us briefly consider what constitutes good "make" in stones other than diamond.

Good "Make" in Colored Stones. Brilliants, cut from materials having smaller refractive indices than diamond, (and this group includes nearly all stones other than diamonds) should have steeper back angles and higher tops than the best diamond brilliants have. A 35-degree top angle (the angle between the slope of the top and the plane of the girdle is called the top angle) and a 41-degree back angle being about ideal for diamond, other gem materials should have more nearly a 39-degree top angle and a 44-degree back angle to give the greatest possible brilliancy. However, in the case of colored gems such as ruby, sapphire, etc., where the value depends even more largely upon the color than upon the brilliancy, it is frequently necessary to cut the brilliant thicker or thinner than these proportions in order to deepen or to thin the color.

In general, the thicker a stone of a given spread the deeper the color will be. The color may also be deepened by giving to the stone a rounded contour, both above and below the girdle, and facetting it in steps instead of in the brilliant form. Increasing the number of steps also serves to slightly deepen the color, as a larger number of reflections is thus obtained within the material, the light thus has to travel a greater distance through the colored mass, and more of the light, of color other than that of the stone, is absorbed.

Improving Color by Proper Cutting. In addition to the color improvement that can be brought about by changing the shape of the cut stone there are a number of gem materials whose color varies very greatly in different directions, and this fact calls for skillful use in order to obtain the best possible results. Thus most tourmalines of deep color must be cut with the top or table, of the finished stone, on the side of the prismatic crystal rather than at right angles to the axis of the prism. If cut the latter way they would be much too dense in color. On the other hand, most blue sapphires should be cut across the prism axis rather than the way that tourmalines should be cut. To cut a sapphire with its table on the side of the prism would be likely to cause it to have a greenish cast because of the admixture of the unpleasing "ordinary ray" of yellowish tint with the blue of the stone as seen up and down the prism. Some Australian sapphires are of a pronounced green when viewed across the axis of the crystal.

Rubies if cut, as was recommended for sapphires, give a very pure and very deep red color, but lack somewhat in the display of dichroism given by rubies that are cut with the table on the side of the crystal and parallel to its axis. Lapidaries need to know and to make use of such optical relations as these and jewelers might well inform themselves in such matters, especially if they have, or hope to acquire, trade in very fine colored stones.

Effect of Shape on Brilliancy. In actual practice it is common to find colored stones poorly cut for brilliancy, especially central brilliancy, and that, too, without the excuse of sacrifice of brilliancy in order to improve color. The fault is usually due to too great a desire to save size and weight. Frequently a stone would have greater value if properly cut, even at the expense of some size and weight. When stones are cut too shallow, as is frequently the case, they are sure to leak light in the center and they are thus weak and less brilliant there than they would be if made smaller in diameter and with steeper back slopes approximating 44 degrees.

Round stones, if their angles are correct, are more brilliant than stones of other contour such as square or cushion shape, or navette or heart shape. It can readily be seen that such odd shaped stones can hardly have the same top and back angles at every part of their circumference. If the angle from a corner of a square stone is correct then the angle from the middle of one side is obviously a little different. Small differences of angle make considerable differences in the brilliancy of cut stones. The prevailing tendency to cut nearly all diamonds round depends largely upon the above facts. In the case of colored stones, however, the added attractiveness which comes with odd or different contour more than makes up for the slight loss of brilliancy that may attend upon the shape selected. Such shapes as lend themselves to special designs in mountings also justify any little loss in brilliancy that accompanies the change in shape, provided the proportions retained give a considerable amount of total reflection within the stone and thus light up most of the stone as seen from the front.